Quote

---

Great job Robert!!! You're almost there.
Now, set a price and start producing!!!
I'm happy for you on this major accomplishment!
Congrats...
Marv

---

Thanks Marv and Mike.

No no, the producing will be done by Steven.
What i can tell you allready, the price which is asked from Bohannon and Motion Performance is high. For me was all the time too high as i did a bit a material research and calculation, but now i know for sure it is.

I know now the exact cost of material and labourtime.

If ever somebody will need panels there will be a good solution for the future. And most important, out of moulds with which good pieces can be produced knowing they dont warp and arent twisted. Cause that can happen by old moulds not built good enough to remain good such long time.
Me and Steven were quite astoneshed how good actually the piece is when it came out of the mould.

Knowing that, my best decision was to buy all those moulds for the complete kit.
It was a bit a gamble as i didn't know the exact condition of the moulds. But the risk was minimised as those moulds was built in 1977 by the best known Corvette fiberglass guru from germany.

Greets
Robert

http://www.cybergate-corp.ch/mako_clip/

"He wandrred around her with glacy eyes, discovering it from all angles.
Then finally he dared to touch her, first gentle.
Then more intens to discover every part of her sexy curves...."

I told you not to laugh, dont want to hear any slippery comments.
If you have them in your mind, go in your garage and check your lady to calm down.

This which then dont feel something should probably change the brand and type of car. LOL

Dont take my words to serious, I am thrild.

Greetings
Robert

http://www.cybergate-corp.ch/mako_clip/

Glad you're having fun with your new toy. ~Tim

Bro' FF

Dave